1 files changed, 44 insertions, 0 deletions
diff --git a/ca/preparing/nondeb-part/sparc.xml b/ca/preparing/nondeb-part/sparc.xml
new file mode 100644
index 000000000..9bcc1239b
--- /dev/null
+++ b/ca/preparing/nondeb-part/sparc.xml
@@ -0,0 +1,44 @@
+<!-- retain these comments for translator revision tracking -->
+<!-- original version: 28997 untranslated -->
+
+
+  <sect2 arch="sparc"><title>Partitioning from SunOS</title>
+
+<para>
+
+It's perfectly fine to partition from SunOS; in fact, if you intend to
+run both SunOS and Debian on the same machine, it is recommended that
+you partition using SunOS prior to installing Debian.  The Linux
+kernel understands Sun disk labels, so there are no problems there.
+Just make sure you leave room for the Debian root partition within the
+first 1GB area of the boot disk. You can also place the kernel image on a
+UFS partition if that is easier than putting the root partition there.
+SILO supports booting Linux and SunOS from either EXT2 (Linux), UFS
+(SunOS), romfs and iso9660 (CDROM) partitions.
+
+</para>
+  </sect2>
+
+  <sect2 arch="sparc"><title>Partitioning from Linux or another OS</title>
+
+<para>
+
+Whatever system you are using to partition, make sure you create a
+<quote>Sun disk label</quote> on your boot disk.  This is the only kind of
+partition scheme that the OpenBoot PROM understands, and so it's the
+only scheme from which you can boot.  In <command>fdisk</command>, the
+<keycap>s</keycap> key is used to create Sun disk labels. You only need to do this
+on drives that do not already have a Sun disk label. If you are using a
+drive that was previously formatted using a PC (or other architecture) you
+must create a new disk label, or problems with the disk geometry will most
+likely occur.
+
+</para><para>
+
+You will probably be using <command>SILO</command> as your boot loader (the
+small program which runs the operating system kernel).
+<command>SILO</command> has certain requirements for partition sizes and
+location; see <xref linkend="partitioning"/>.
+
+</para>
+  </sect2>