diff options
Diffstat (limited to 'en/boot-installer/arm.xml')
-rw-r--r-- | en/boot-installer/arm.xml | 40 |
1 files changed, 25 insertions, 15 deletions
diff --git a/en/boot-installer/arm.xml b/en/boot-installer/arm.xml index 46f90a61d..46f767ac1 100644 --- a/en/boot-installer/arm.xml +++ b/en/boot-installer/arm.xml @@ -184,22 +184,24 @@ just powercycle the machine and try again. </footnote>. This will give you the RedBoot prompt. Enter the following commands: -</para> - <informalexample><screen> load -v -r -b 0x01800000 -m ymodem ramdisk.gz load -v -r -b 0x01008000 -m ymodem zImage exec -c "console=ttyS0,115200 rw root=/dev/ram mem=256M@0xa0000000" -r 0x01800000 </screen></informalexample> -<para>After every 'load' command, the system will expect a file to be -transmitted using the YMODEM protocol. When using cu, make sure you have -the package <quote>lrzsz</quote> installed, then hit enter, followed by -the <quote>~<</quote> escape sequence to start an external program, -and run <command>sb initrd.gz</command> or <command>sb -vmlinuz</command>.</para> +</para><para> -<para>Alternatively, it is possible to load the kernel and ramdisk using +After every <command>load</command> command, the system will expect a +file to be transmitted using the YMODEM protocol. When using cu, make +sure you have the package <classname>lrzsz</classname> installed, then +hit enter, followed by the <quote>~<</quote> escape sequence to start +an external program, and run <command>sb initrd.gz</command> or +<command>sb vmlinuz</command>. + +</para><para> + +Alternatively, it is possible to load the kernel and ramdisk using HTTP rather than YMODEM. This is faster, but requires a working HTTP server on the network. To do so, first swith the bootloader to RAM mode: @@ -207,20 +209,28 @@ server on the network. To do so, first swith the bootloader to RAM mode: fis load rammode g </screen></informalexample> -<para>This will seemingly restart the machine; but in reality, it loads + +</para><para> + +This will seemingly restart the machine; but in reality, it loads reboot to RAM and restarts it from there. Not doing this step will cause -the system to hang in the necessary ip_address step that comes -next.</para> -<para>You will need to hit Ctrl-C again to interrupt the boot. -Then:</para> +the system to hang in the necessary ip_address step that comes next. + +</para><para> + +You will need to hit Ctrl-C again to interrupt the boot. Then: + <informalexample><screen> ip_address -l 192.168.2.249 -h 192.168.2.4 load -v -r -b 0x01800000 -m http /initrd.gz load -v -r -b 0x01008000 -m http /zImage exec -c "console=ttyS0,115200 rw root=/dev/ram mem=256M@0xa0000000" -r 0x01800000 </screen></informalexample> -<para> + +</para><para> + The installer will now start as usual. + </para> </sect3> </sect2> |