To install the system via NFS, simply select NFS for the location of the images and files and follow the instructions provided. You will be prompted for the server:/directory where the images are located. &boot-installer-intro-net.xml; On machines with OpenBoot, simply enter the boot monitor on the machine which is being installed (see ). Use the command boot net to boot from a TFTP and RARP server, or boot net:dhcp to boot from a TFTP and DHCP server. Some older OpenBoot revisions require using the device name, such as boot le(); these probably don't support DHCP. &boot-installer-intro-cd.xml; Most OpenBoot versions support the boot cdrom command which is simply an alias to boot from the SCSI device on ID 6 (or the secondary master for IDE based systems). You may have to use the actual device name for older OpenBoot versions that don't support this special command. Note that some problems have been reported on Sun4m (e.g., Sparc 10s and Sparc 20s) systems booting from CD-ROM. To boot from floppy on a Sparc, use Stop-A -> OpenBoot: "boot floppy" Be warned that the newer Sun4u (ultra) architecture does not support floppy booting. A typical error message is Bad magic number in disk label - Can't open disk label package. Furthermore, a number of Sun4c models (such as the IPX) do not support the compressed images found on the disks, so also are not supported. Several Sparcs (e.g. Ultra 10) have an OBP bug that prevents them from booting (instead of not supporting booting at all). The appropriate OBP update can be downloaded as product ID 106121 from . If you are booting from the floppy, and you seem messages such as Fatal error: Cannot read partition Illegal or malformed device name then it is possible that floppy booting is simply not supported on your machine. If you cannot boot because you get messages about a problem with ``IDPROM'', then it's possible that your NVRAM battery, which holds configuration information for you firmware, has run out. See the Sun NVRAM FAQ for more information.