From c145ff25d9557cb81de7a9adb246136387786930 Mon Sep 17 00:00:00 2001 From: Martin Michlmayr Date: Tue, 7 Mar 2006 18:37:08 +0000 Subject: misc updates --- en/boot-installer/arm.xml | 16 ++++++++-------- 1 file changed, 8 insertions(+), 8 deletions(-) (limited to 'en/boot-installer/arm.xml') diff --git a/en/boot-installer/arm.xml b/en/boot-installer/arm.xml index 963c3d1c4..2abad7171 100644 --- a/en/boot-installer/arm.xml +++ b/en/boot-installer/arm.xml @@ -9,9 +9,9 @@ -Netwinders have two network interfaces: The 10Mbps NE2000-compatible -card is eth0 and the 100Mbps Tulip card is -eth1. +Netwinders have two network interfaces: A 10Mbps NE2000-compatible +card (which is generally referred to as eth0) and +A 100Mbps Tulip card. @@ -39,8 +39,10 @@ from -After rebooting and interrupting the boot process during the countdown, you -must first configure the network either with a static address: +When you boot your Netwinder you have to interrupt the boot process during the +countdown. This allows you to set a number of firmware settings needed in +order to boot the installer. You must first configure the network, either +with a static address: NeTTrom command-> setenv eth0_ip 192.168.0.10/24 @@ -80,9 +82,7 @@ need the following setting: Use the printenv command to review your -environment settings. Finally, if your cmdappend -NeTTrom variable has the option, you must -remove it so the downloaded kernel can boot with its attached ramdisk. +environment settings. -- cgit v1.2.3