diff options
Diffstat (limited to 'nl/install-methods/boot-usb-files.xml')
| -rw-r--r-- | nl/install-methods/boot-usb-files.xml | 26 |
1 files changed, 14 insertions, 12 deletions
diff --git a/nl/install-methods/boot-usb-files.xml b/nl/install-methods/boot-usb-files.xml index 1ac9adbba..b669d9c2b 100644 --- a/nl/install-methods/boot-usb-files.xml +++ b/nl/install-methods/boot-usb-files.xml @@ -1,22 +1,22 @@ <!-- retain these comments for translator revision tracking --> -<!-- original version: 32124 untranslated --> +<!-- original version: 36841 untranslated --> <sect1 condition="bootable-usb" id="boot-usb-files"> <title>Preparing Files for USB Memory Stick Booting</title> <para> -For preparing the USB stick you will need a system where GNU/Linux is +To prepare the USB stick, you will need a system where GNU/Linux is already running and where USB is supported. You should ensure that the usb-storage kernel module is loaded (<userinput>modprobe usb-storage</userinput>) and try to find out which SCSI device the USB stick has been mapped to (in this example <filename>/dev/sda</filename> is used). To write to your stick, you -will probably have to turn off its write protection switch. +may have to turn off its write protection switch. </para><para> -Note, that the USB stick should be at least 128 MB in size (smaller +Note that the USB stick should be at least 128 MB in size (smaller setups are possible if you follow <xref linkend="usb-copy-flexible"/>). </para> @@ -81,12 +81,15 @@ should use the following method to put the files on your stick. &usb-setup-i386.xml; &usb-setup-powerpc.xml; - <sect3> + </sect2> + <sect2> <title>Adding an ISO image</title> <para> -Now you should put any Debian ISO image (businesscard, netinst or even -a full one) onto your stick (if it fits). The file name of such an +The installer will look for a Debian ISO image on the stick as its source +for additional data needed for the installation. So your next step is to +copy a Debian ISO image (businesscard, netinst or even a full CD image) +onto your stick (be sure to select one that fits). The file name of the image must end in <filename>.iso</filename>. </para><para> @@ -104,11 +107,11 @@ When you are done, unmount the USB memory stick (<userinput>umount /mnt</userinput>) and activate its write protection switch. </para> - </sect3> + </sect2> - <!-- TODO: doesn't this section belong later? --> - <sect3 arch="i386"> - <title>Booting the USB stick</title> + <!-- TODO: doesn't this section belong later? --> + <sect2 arch="i386"> + <title>Booting the USB stick</title> <warning><para> If your system refuses to boot from the memory stick, the stick may @@ -121,6 +124,5 @@ contain an invalid master boot record (MBR). To fix this, use the </screen></informalexample> </para></warning> - </sect3> </sect2> </sect1> |